<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
  <meta content="text/html;charset=ISO-8859-1" http-equiv="Content-Type">
  <title></title>
</head>
<body bgcolor="#ffffff" text="#000000">
Hello Daniel<br>
<br>
Thanks for that. At least I know what each is supposed to do.<br>
<br>
The WG311 is based on the ACX111 from Texas Instrument.<br>
There is actually a sourceforge project for that, but the documentation
is either made for martians or people from another world. I have not
spent much time on it either I must admit. <br>
I went straight to ndiswrapper, at least I know that the card is
working.<br>
I have not ifup.down under Zenwalk for wlan0.<br>
Anyway I tried again the <br>
iwconfig wlan0 essid Frogs<br>
<br>
Still no modif.. <br>
Same for acces point, can't change it ... <br>
however I could change from "restricted" to "managed".<br>
I just don't get it....<br>
Cheers<br>
E<br>
<br>
<br>
<br>
Daniel Pittman wrote:
<blockquote cite="mid874p4cwbmf.fsf@rimspace.net" type="cite">
  <pre wrap="">E Chalaron <a class="moz-txt-link-rfc2396E" href="mailto:e.chalaron@xtra.co.nz">&lt;e.chalaron@xtra.co.nz&gt;</a> writes:

  </pre>
  <blockquote type="cite">
    <pre wrap="">I have a netgear wireless pci card WG311.  Got to wake it up with
ndiswrapper under Zenwalk and appears as wlan0 :-D
    </pre>
  </blockquote>
  <pre wrap=""><!---->
ndiswrapper?  Good luck; in my experience that seldom works
effectively.  Are you sure there isn't an open driver for the hardware?
Which chipset is it anyhow?

  </pre>
  <blockquote type="cite">
    <pre wrap="">However ....

iwconfig and iwlist are giving me 2 different results &gt;:o
    </pre>
  </blockquote>
  <pre wrap=""><!---->
Of course they are: iwlist shows you which access points are visibile,
while iwconfig shows how the card is currently configured.

  </pre>
  <blockquote type="cite">
    <pre wrap="">I tried to conform iwconfig with iwlist but without any success.
(essid, protocol, access point)... nothing at ALL ...
    </pre>
  </blockquote>
  <pre wrap=""><!---->
Usually you would set the card to managed mode, then set the essid to
whatever your network was; the rest should take care of itself.

By "usually", I actually mean: most people, these days, would simply use
the tools supplied by their distribution that manage all of this
automatically; ifupdown or equivalent on your platform can probably take
care of most of it automatically.

Regards,
        Daniel


  </pre>
</blockquote>
</body>
</html>