[wellylug] SME Server problems

[Mark Signal]

It most probably won't work using the hardware ide raid without major driver
agonies - suggest you use software raid option.

make sure that its not set to boot off of cdrom first in bios - this seems
to stuff up software raid

also remember it will run like custard for a few hours while the disks sync

cat /proc/mdstat to see disk sync %

cheers

Mark Signal


-----Original Message-----
From: wellylug-admin at lists.naos.co.nz
[mailto:wellylug-admin at lists.naos.co.nz]On Behalf Of Michael Dittmer
Sent: Tuesday, 29 June 2004 7:02 p.m.
To: wellylug at lists.naos.co.nz
Subject: [wellylug] SME Server problems


Hi All...

I have just installed SME Server 6.0.1 on a box for a client. The install
went fine except when I reboot the box or shut it down and then start it up
again it doesn't boot into SME Server.

I can boot SME using the the rescue floppy, but I need it to boot using LILO
like it should. I am using the PX865PE Pro II motherboard from Albatron and
the 2 120GB hard-drives are operating off the IDE RAID.

If someone can give me some hints to fix?

BTW, the system sees (when booted off the floppy) the two hard-drives (RAID
1) as hde.

Thanks

Michael


--
Wellington Linux Users Group Mailing List: wellylug at lists.naos.co.nz
To Leave:  http://lists.naos.co.nz/mailman/listinfo/wellylug

---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.712 / Virus Database: 468 - Release Date: 27/06/2004

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.712 / Virus Database: 468 - Release Date: 27/06/2004